Remmers MB 2K; 25 kg, 2-component mineral waterproofing

Flexible polymer thick film coating (FPD). It combines the properties of an elastic, crack bridging, mineral sealing slurry (MDS) (general test certificate: P-5344/081/14 MPA-BS) and a bituminous thick coating (PMBC) - test report in accordance with EN 15814

• Proven bridging capacity for cracks over 3mm wide! (according to EN 14891)
• Fast drying and cross-linking after only 18 hours
• Meets PMBC requirements
• Proven radon tightness
• The product does not contain solvents
• The product does not contain bitumen
• Water tightness under pressure
• High peel strength
• Very good adhesion, including on non-mineral substrates such as plastics, metals, etc.
• High flexibility, expansion and crack bridging ability
• Cladding possible only 4 hours after application.
< li> Resistant to UV radiation
• Resistant to frost and thawing salts
• The coating can be painted and plastered
• The material can be applied by brush, roller, trowel and spraying equipment

Application

• Rapid Waterproofing
• Waterproofing of New Construction
< li> As a horizontal waterproofing in Wed. walls and under them
• For internal insulation of existing structures in accordance with WTA 4-6 instructions
• Installation at depths & gt; 3 m
• For sealing joints in water impermeable concrete structures
• Sealing plinths
• Composite waterproofing
• As a bonding layer on old bituminous coatings < / li>
• For repairing flat roof seals above uninhabited spaces

• Requirements for the substrate

  The substrate must be even, load-bearing, dry, clean, free from dust, oil, grease and release agents.

  Non-mineral substrates must be treated roughness.

• Preparations

  Remove protruding joints and mortar residues. < / p>

  Corners and edges should be rounded or chamfered.

  In the case of facets, VF strips should be embedded in the material and rounded to & lt; 20 mm.

  Alternatively, make the sealing bevel out of a suitable mortar.

  Recesses & gt; 5 mm, fill with a suitable filler or MB 2K with Selectmix RMS, mixing ratio 1: 1 to 1: 3.

  Roughen the plastic pipes with sandpaper. Clean metal pipes, sand them if necessary.

  If necessary, protect against rising damp.

  Mineral surfaces should be primed with Kiesol MB

  As a bonding layer, and in order to prevent blistering, the surface is covered with a scratching putty made of MB 2K in an amount of approx. 500 g / m?.

Translations of product names and their descriptions have been translated using Google Translate.