WEBER ZP413 tile adhesive 25 kg C1TE

The most important properties of the product: - significantly reduced dusting of the product - for stoneware, non-absorbent stone and clinker, glaze and terracotta - for damp and wet rooms and outdoors - for gypsum substrates - maximum tile size: 40 x x40 cm - medium-layer, up to 15 mm - reduced runoff - frost-resistant and waterproof. Application of the product: Weber ZP413 adhesive mortar was produced in an innovative technology reducing dusting during pouring and mixing, therefore it is especially recommended for working in confined spaces. Significant reduction of the degree of dust with cement dust and air dust, improves the comfort of work in a noticeable way and shortens the time of cleaning works. Weber ZP413 adhesive can be used indoors and outdoors, both in residential construction and on substrates with increased usable load, e.g. floors in commercial, service and industrial facilities. It is intended for laying glazed and terracotta tiles, porcelain tiles and non-absorbent stone, up to 40x40 cm in size, on walls and floors. The base for the cladding can be: - concrete, - traditional cement and cement-lime plaster, - gypsum plaster, - gypsum boards, - cement and anhydrite screed, - raw surfaces made of small-size elements: brick, blocks, concrete and ceramic blocks, silicate. - The mortar can be used to level the surfaces for the tiles to be laid on the walls (one layer thickness is 2-15 mm), and for building small elements, e.g. bathtub or shower tray covers, etc. The mortar can be used outdoors, but frost-resistant tiles should be used . Recommendations: - Especially recommended for work in confined spaces - non-dusting product. - Recommended for gres tiles, gypsum plasters and gypsum boards. - For use on surfaces with increased operational load - staircases, lobbies, corridors, walls and floors. - Not suitable for tile waterproofing, underfloor heating, ceramic tiles, terrazzo and OSB. - Do not apply adhesive mortar to the tile in points. The temperature during application and bonding should not be lower than + 5 ° C and higher than + 25 ° C. during application and bonding, avoid direct sunlight and moisture, protect against rain. IMPORTANT! Classes of adhesives for tiles Adhesives are classified on the basis of the European standard PN EN 12004. According to it, adhesive mortars are divided by type and class. There are types of adhesives (due to their chemical composition): C - cement, D - dispersion, R - reactive (based on synthetic resins: polyurethane and epoxy). Due to technical parameters, the classes of adhesives are: 1 - normally binding, 2 - with enhanced parameters. Due to additional requirements, the classes of adhesives are: F - fast-setting, T - with reduced flow, E - with extended open time. Additionally, according to the PN EN 12002 standard, adhesive mortars can be divided according to their transverse deformation into: S1 - deformable adhesives - from 2.5 to 5 mm, S2 - highly deformable adhesives - over 5 mm. Thus, mortar marked with C2 symbol has better adhesion properties than ordinary class C1 mortars. The adhesive marked C2 S1 is additionally characterized by deformability, and C2 S2 - high deformability. The C2 TE mortar is a quick-setting cementitious adhesive with increased adhesion and reduced flow, C2 FT S1 - a quick-setting deformable cement adhesive with increased adhesion and reduced flow.

Translations of product names and their descriptions have been translated using Google Translate.