Weber.tec Superflex D24 - Hydroizolacja mineralnna - 24 kg

Product highlights

• fast setting, can be further processed after 90 minutes,
• after 4 hours can be pedestrianized and tiled,
• drying independent of weather conditions - chemical bond,
• extremely easy processing,
• binds without the appearance of scratches and residual stress, also under wind and UV radiation loads,
• very good adhesion to the substrate,
• high tightness, also when the water pressure tears the waterproofing from the substrate,
• bridging of cracks over 2 mm wide, even at low temperatures,
< li> resistant to frost, aging and UV radiation,
• does not require any further surface protection,
• can be covered with ceramic cladding and tiles.

Application of the product

• for horizontal and vertical waterproofing of underground parts of buildings and structures such as as:
• continuous footings,
• foundation walls,
• foundation slabs,
• for waterproofing plinth areas of buildings,
< li> for waterproofing with negative water pressure (tearing off the waterproofing from the substrate) - a depth of up to 3 m below the groundwater table,
• for secondary insulation of buildings and structures (walls, floors), also of the bath type,
• for sealing water tanks, also drinking water (up to 15 m water column), swimming pools, sewage treatment tanks,
• for combined (under-tile) sealing of balconies and terraces,
< li> for waterproofing damp and wet rooms (showers, bathrooms, etc.),
• as a pre-sealing and bonding layer for polymer-bituminous sealing compounds (KMB),
• for temporary waterproofing during construction,
• bonding layer on existing bituminous (asphalt) coatings.

Waterproofing depends on the rod seizure of the sealed structure, moisture / water loads, presence of aggressive media, etc.

Product preparation

The liquid and powder components are supplied in the correct proportions. Add the powder component to the liquid component and mix with a low-speed mixer or a drill with a paddle mixer until a homogeneous, homogeneous mass is obtained. Avoid air entrainment during mixing. The mixing time is 2-3 minutes, then a 1-2 minute break is necessary and a short remixing is required. The prepared micro-mortar is ready for application.
Prepare the amount of material that can be used during the processing.

Conditions during application and setting

Temperature of the substrate and air during the performance of the work should be between + 3 ° C and + 30 ° C. Do not apply the material on the frozen substrate, do not work in negative temperatures or during rainfall.
Protect the freshly applied waterproofing layer from drying too quickly. Avoid strong wind and direct sunlight on the processed surface. You should follow the rules of building art. Protect the fresh waterproofing layer against frost and rain for at least 4 hours.

Translations of product names and their descriptions have been translated using Google Translate.